Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Test curve for water
#1
Hi, I just installed a bpod (2.0), everything seems to work fine, except for the water valve (Bpod set up using only 1 water valve and no other modules). I am not sure it uses the calibration file...
Water valve is working and delivers water, I can calibrate new values in the calibration file but if I want to test it with the test curve, I have an error message and I cannot test the valve.
Any ideas? see below the error message


"Error using BpodLiquidCalibration>RunRewardCal (line 575)
Pulse durations should be specified in seconds.

Error in BpodLiquidCalibration>RunSpecificAmount (line 808)
    Completed = RunRewardCal(nPulses, TargetValves, PulseDurations, .2);
 
Error while evaluating UIControl Callback."


Thanks!
Sarah
Reply
#2
Hi Sarah,


Please send your liquid calibration file to support@sanworks.io, and I'll have a look.
The file is in your /Bpod Local/ folder:

/Bpod Local/Calibration Files/LiquidCalibration.mat

Thanks,
Josh
Reply
#3
(05-27-2019, 09:25 PM)Josh Wrote: Hi Sarah,


Please send your liquid calibration file to support@sanworks.io, and I'll have a look.
The file is in your /Bpod Local/ folder:

/Bpod Local/Calibration Files/LiquidCalibration.mat

Thanks,
Josh

Thks!
I sent you the file from my gmail address.

Best,
Reply


Forum Jump: