TriangleThesis I was wondering if it is possible to configure a module port on the r2.5 state machine as a TTL out port, or if a separate module is required. In my setup, both TTL out ports are occupied and I need one more output. Thank you!
Josh Hello Triangle, Unfortunately the module port has only RS-485 and 9V power channels. You'll need a module. For extra TTL you may consider using an Arudino Shield with Arduino Zero. You can load the DIO firmware example to the Zero for 6 additional digital outputs and 6 additional digital inputs. If you have behavior ports that are not using their LED channel, that can also be used as a 3.3V TTL, accessed via the LED +/- screw terminals on the port interface board. I hope this helps, Josh
