Bpod Console Manual Override bug

Kovax

Hi!

I am using Bpod statemachine r05, with firmware 22 with Matlab with Bpod Console v1.64 and i have this bug, that during a trial manually opening the valves by pressing the vlv1 button turns it green and pressing it again in order to close the solenoid, it does not close the solenoid, the green light turns red, but water still comes through the solenoid, this error persist on another setup with same r05 statemachine same FW and Matlab. Is there are a way i can fix this issue? I am doing a hard behavioral protocoll for mice, and in order to help them i want to use this manual override.

Thanks so much!

Péter

Josh

Hi Péter,

A few questions:
Which version of MATLAB are you using?
Do you have PsychToolbox installed?
Is the valve connected to the state machine via a port interface board?
Do you have other rigs with FSM 0.5 + Bpod Console v1.64 that don't have the issue?

As always I suggest updating to the latest version of Bpod Console (v1.71) and the state machine firmware (v23).

-Josh

Kovax

Josh wrote[quote='Josh' pid='4567' dateline='1674502012']
Hi Péter,

A few questions:
Which version of MATLAB are you using?
Do you have PsychToolbox installed?
Is the valve connected to the state machine via a port interface board?
Do you have other rigs with FSM 0.5 + Bpod Consolve v1.64 that don't have the issue?

As always I suggest updating to the latest version of Bpod Console (v1.71) and the state machine firmware (v23).

-Josh

Hi Josh!

Matlab is ver 2016, but it seems matlab independent, Psychtoolbox is installed, and the lickport is connected with port interface board, and voltages are all correct, with more errors, i noticed that the behaviour is repeatable, the issue is when the statemachine jumps from one state to another, and the manual override happened during that exact period.

- Péter