PulsePal won't turn on

vfmcw

Hi,

I believe I may have tried to setup the PulsePal and Arduino twice, which has resulted in the device not turning on when plugged into a USB port. The first time I followed the instructions for the wiki, but the second time was through MatLab asking for an Arduino add-on, which resulted in this error.

The error log is attached. Any help would be appreciated.

Josh

Hello,

Looks like MATLAB may have tried to put Firmata firmware on the board.
You can restore Pulse Pal firmware using the instructions here.

Please write in if you run into any issues.

Thanks,
-Josh