BNC input logic

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
BNC input logic
#1
Hello everyone!
I was wondering if the State Machine accepts a 0-5V logic (I want to use an arduino's digital input to trigger a new state) with 0 being the LOW level and 5V being the HIGH.

Thanks in advance!
Have a great day
Reply
#2
Hi Marco,

All of the state machine's digital input channels are 5V tolerant - so you can definitely use an Arduino board to trigger a state change! You'd configure the Arduino pin as an output (not an input). Just make sure the incoming pulse lasts for at least 200 microseconds.

-Josh
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)