I have one additional question,
I an trying to upload firmware for the analog output 4 ch,
In the Arduino software I chose board Teensy3.6 (as instructed in the wiki), but when I am trying to choose the port it only recognizes it as COM7 (Teensy 3.1/3.2).
If I try to upload the firmware I get the following error:
Low memory available, stability problems may occur.
Previously selected Teensy port is offline.
1 other Teensy board found. Please select
this Teensy from the Tools > Ports menu.
I guess I own an older version so I chose board teensy 3.1/3.2 and tried to upload again,
This time I get the following error message:
exit status 1
'SdFatSdioEX' does not name a type
I followed the instructions I found here in the forum, but it wasn't helpful.
Any advise would be helpful,
Noa