Hello,
I've been trying to implement the bpod system, sending 5V triggers (sustained for 50 ms) at appropriate timings to a NIDAQ system connecting to a two-photon microscope that runs with ScanImage 4 software. There is not much support for ScanImage 4 anymore, as it has been discontinued.
The previous system was bcontrol. Using the same trigger configurations (with Scheduled Waves), at the same 5V and timings, ScanImage receives the triggers and functions as desired. However, with bpod, even though the outputs look the same, they create errors of triggering in the said software. I have tried connecting a power source to bpod, to compensate for any current troubles. I have also grounded every component to the same port.
Do you have any idea about where the triggers could be differing?
Thank you in advance!
Beatriz