Thread Rating:
  • 1 Vote(s) - 3 Average
  • 1
  • 2
  • 3
  • 4
  • 5
PokesPlot in Bpod

I'm using the 2nd Gen Bpod with Matlab, and I was wondering if there is any code ready or in development to implement the plot showing current state, like the PokesPlot of Bcontrol.

Thanks Smile
Hi Marina,

Bpod has a variant of PokesPlot (also see its use in this example protocol) - but it currently updates once per trial, when the trial is complete.

The lack of updates during the trial is historical - in older Bpod firmware/software, timing information was not returned until after the trial. There is no reason why it couldn't be added to native Bpod the future; with the current firmware, BrodyLab's PokesPlot works fine if you're using BControl with Bpod hardware.

I hope this helps,

Forum Jump: