Pulse Pal Hardware installation

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Pulse Pal Hardware installation
#4
Hi Dymphie,

It sounds like you're trying to get Pulse Pal talking to MATLAB - you shouldn't need to update the firmware to do this.
However, since Arduino can't see the board, I'm worried that your drivers didn't correctly install.
From the device manager, do you see a "Serial Ports" category? If so, could you please share the list of devices you find there? 
Also please list any "unknown devices" (I think in XP they're displayed with a yellow triangle)

Thanks
-Josh
Reply


Messages In This Thread
Pulse Pal Hardware installation - by dsuchan - 02-16-2018, 07:36 PM
RE: Pulse Pal Hardware installation - by Josh - 02-16-2018, 11:26 PM
RE: Pulse Pal Hardware installation - by dsuchan - 02-16-2018, 11:59 PM
RE: Pulse Pal Hardware installation - by Josh - 02-17-2018, 07:11 PM
RE: Pulse Pal Hardware installation - by dsuchan - 02-19-2018, 04:37 PM
RE: Pulse Pal Hardware installation - by Josh - 02-19-2018, 07:59 PM
RE: Pulse Pal Hardware installation - by dsuchan - 02-19-2018, 09:11 PM
RE: Pulse Pal Hardware installation - by Josh - 02-21-2018, 03:01 AM
RE: Pulse Pal Hardware installation - by dsuchan - 02-21-2018, 04:35 PM
RE: Pulse Pal Hardware installation - by dsuchan - 02-21-2018, 06:27 PM
RE: Pulse Pal Hardware installation - by Josh - 02-21-2018, 08:25 PM

Forum Jump: