Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
BNC input logic
#2
Hi Marco,

All of the state machine's digital input channels are 5V tolerant - so you can definitely use an Arduino board to trigger a state change! You'd configure the Arduino pin as an output (not an input). Just make sure the incoming pulse lasts for at least 200 microseconds.

-Josh
Reply


Messages In This Thread
BNC input logic - by MarcoC - 03-10-2020, 01:54 PM
RE: BNC input logic - by Josh - 03-11-2020, 08:28 PM

Forum Jump: