Increasing max number of waveforms on AOM
The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.2.30 (Linux)
File Line Function
/showthread.php 864 errorHandler->error




Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Increasing max number of waveforms on AOM
#1
Josh,

Basically I'm just tinkering so I can better understand how these things work.  I wanted to see if it was possible to increase the number of sounds (waveforms) the AOM can play running the BpodAudioPlayer_Live firmware.  I presume the two lines I need to adjust are:

const byte maxWaves = 20;
const uint32_t bufSize = 2000;

As currently configured almost all the teensy 3.6's memory is used up.  Therefore I figured if I wanted to increase the number of waves I'd need to decrease the buffer size.  And while I can decrease the buffer size to 1000 (things still play fine if maxWaves stays at 20), and I can decrease the maxWaves value below 20 (things play fine keeping maxWaves at 20 even if I increase bufSize above 2000), if I try to increase the maxWaves, say to 21 or 22 and decrease bufSize so a comparable amount of memory is used ~95%, the sounds simply don't play.  There are no errors in either Arduino when compiling and uploading, or matlab when running, just no sound output. Is there another variable or line I need to change?

Thoughts?

On a related note, are there any thoughts to upgrading Bpod and modules to run with teensy 4x at its core (high clock speed and more onboard memory could mean more sounds sampled at a higher rate than 44.1kHz)?

Thanks
Chuck
Reply


Messages In This Thread
Increasing max number of waveforms on AOM - by ckopec - 02-19-2020, 03:17 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)