Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
DC Barrel Jack PCB cutout
#2
Hi Chuck,

Some board houses had trouble with the slits in that part. I solved this by choosing a different footprint.

The new footprint has larger holes, but it works with the same part. The 3 holes are spread out a touch, so that the jack stays in place when pressed in (for easier soldering). It may require a light twist to make it point straight out.

-Josh
Reply


Messages In This Thread
DC Barrel Jack PCB cutout - by ckopec - 02-18-2020, 06:52 PM
RE: DC Barrel Jack PCB cutout - by Josh - 02-18-2020, 07:59 PM

Forum Jump: