Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
if statement
#1
Hi,
I need to program an "if statement" into my PulsePal script and I'm not really sure how to do this. Basically, I need the following: A TTL detected on Trigger channel 1, then the programed stimulus should start, however, a TTL detected on Trigger channel 2 and the programed stimulus should stop. It sounds pretty straight forward but I simply do not know how to communicate this to the PulsePal. Any advice would be greatly appreciated.

Thanks a bunch,
Ilja
Reply


Messages In This Thread
if statement - by Ilja - 02-13-2020, 10:23 PM
RE: if statement - by Josh - 02-16-2020, 02:11 AM
RE: if statement - by Ilja - 02-18-2020, 11:42 PM
RE: if statement - by Ilja - 02-19-2020, 09:57 PM
RE: if statement - by Ilja - 02-27-2020, 06:25 PM

Forum Jump: