bpod not lighting on

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
bpod not lighting on
#1
Hi josh

any idea of why the bpod would  stop working after uploading firmware? 
this is what i did:
- bpod is connected, matlab installed, state machine (r2) firmware uploaded, and tried running a valve through one of the ports and it works
- not i tried uploading the rotary encoder module firmware, while the bpod was connected. I think i messed it up as i am not sure if the rotary encoder firmware should be uploaded to the state machine. 

Now the bpod is not even lighting on when powered. Is there a way to reset it? 

thanks
sandra
Reply


Messages In This Thread
bpod not lighting on - by sandraromerop - 05-27-2019, 05:04 PM
RE: bpod not lighting on - by Josh - 05-27-2019, 09:17 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)