Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
PulsePalWavGen square pulse with ramp down
#3
Thank you for the quick and helpful response, Josh! Everything worked perfect, and was easy to adapt for my initial experiments.

I have a related question: the duration of my square waveform with 200ms ramp down will eventually need to depend on a TTL into triggerCh1 to generate a square step on to output ch1, and ideally a second TTL pulse to triggerCh1 that toggles output ch1 to ramp down linearly from 5V. In other words, I would need a single square waveform that ramps down but the waveform duration depends on the time between TTL pulses to the same trigger channel.

I was unsure if the customWaveform function has the ability to toggle a signal in this manner or if I should be looking elsewhere. Any direction or alternate suggestions would be greatly appreciated. Thank you so much for your help!
Reply


Messages In This Thread
RE: PulsePalWavGen square pulse with ramp down - by scop - 05-04-2017, 10:16 PM

Forum Jump: