MED box output to Pulsepal Trigger

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
MED box output to Pulsepal Trigger
#1
Hi everyone,

I have a Pulsepal trigger channel hooked up to a MED behavior box output channel at 5 volts, and I found that the Pulsepal trigger responds only in the pulse-gated mode, but not the normal mode. Would anybody have any ideas to what kind of signal can cause this outcome?

Thank you!
Ben
Reply


Messages In This Thread
MED box output to Pulsepal Trigger - by neuralcircuit - 04-20-2019, 05:19 AM
RE: MED box output to Pulsepal Trigger - by Josh - 04-25-2019, 01:44 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)