ttl channel outputs in State Machine r2

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ttl channel outputs in State Machine r2
#1
To whom it may concern,

I am pretty new to Bpod (and Matlab) and looking for some advise as to how to drive different components using the State Machine r2. 

Up to now, we have been performing experiments using the previous version State Machine r1 and used the bare wires or ttl ports to directly drive the different components of the setup (e.g. stimulus apparatus, several speakers, triggers for scanimage software  and shatter). These were physically accessible from the bpod arduino board and could be directly coded into the state matrix. We have recently purchased the new Bpod machine r2 and I would like to know what's the best way to go in order to drive several components while having only 2 ttl input/output. Also how much coding would this require? it would be great to have a sample code just to have an idea. Thanks. Dani
Reply


Messages In This Thread
ttl channel outputs in State Machine r2 - by Dani182 - 02-13-2019, 01:45 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)