01-23-2019, 06:30 AM
Hi Sam,
Is it possible that there is a second state machine with old firmware attached to the same PC?
It would only say v19 if it was reading '19' from the device.
If you connect to the state machine with known v22 firmware using a serial port argument, does it work?
e.g. Bpod('COM3'), where 'COM3' is the known v22 state machine's USB serial port
-Josh
Is it possible that there is a second state machine with old firmware attached to the same PC?
It would only say v19 if it was reading '19' from the device.
If you connect to the state machine with known v22 firmware using a serial port argument, does it work?
e.g. Bpod('COM3'), where 'COM3' is the known v22 state machine's USB serial port
-Josh