Sync Bpod with microscope frame acquisition

Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Sync Bpod with microscope frame acquisition
#1
Hi Josh,

I would like to do imaging while controlling behavior with Bpod, but I am not sure how to sync the two acquisitions. I connected the output of the frame trigger that is sent by the microscope hardware to one of the digital inputs of Bpod, but I am missing pulses (the number of frames acquired is higher than the TTL pulses detected with Bpod). What is the best way to do this?

Thanks,
Sara
Reply


Messages In This Thread
Sync Bpod with microscope frame acquisition - by Sara - 01-17-2019, 11:04 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)