Pulse Pal Hardware installation
The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.2.30 (Linux)
File Line Function
/showthread.php 864 errorHandler->error




Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Pulse Pal Hardware installation
#1
Hi,
I received my Pulse Pal v. 2 yesterday and wanted to install it today. I followed the Sanworks link to the Pulse Pal WIKI and started with the installation of the Pulse Pal on my Windows XP desktop. I was not sure on whether to already connect the device vis USB to the computer but I decided to anyway. I downloaded the repository and placed it into the appropriate location on the computer. 
I know I need the drivers to be able to run Pulse Pal but I'm not quite sure how to install these from the downloaded repository so instead I thought it best to upgrade the firmware, which most likely also contains the appropriate drivers. I thus downloaded Arduino and followed the instructions on that WIKI page. Problem arose with determining the Com port. As the USB connection should create a virtual Com port I checked the system/Device manager settings for the ports but it does not seem to be present. When I remove the USB from the computer all are still present, none disappear when I disconnect. I did try other USB port, both in front as well as in back but nothing changes.
I'm sorry this is such a simple question but I'm simply stuck at this point and I wish I could continue and finally use the Pulse Pal. Sad

Any advice would be greatly appreciated,

Dymphie Suchanek
Reply


Messages In This Thread
Pulse Pal Hardware installation - by dsuchan - 02-16-2018, 07:36 PM
RE: Pulse Pal Hardware installation - by Josh - 02-16-2018, 11:26 PM
RE: Pulse Pal Hardware installation - by dsuchan - 02-16-2018, 11:59 PM
RE: Pulse Pal Hardware installation - by Josh - 02-17-2018, 07:11 PM
RE: Pulse Pal Hardware installation - by dsuchan - 02-19-2018, 04:37 PM
RE: Pulse Pal Hardware installation - by Josh - 02-19-2018, 07:59 PM
RE: Pulse Pal Hardware installation - by dsuchan - 02-19-2018, 09:11 PM
RE: Pulse Pal Hardware installation - by Josh - 02-21-2018, 03:01 AM
RE: Pulse Pal Hardware installation - by dsuchan - 02-21-2018, 04:35 PM
RE: Pulse Pal Hardware installation - by dsuchan - 02-21-2018, 06:27 PM
RE: Pulse Pal Hardware installation - by Josh - 02-21-2018, 08:25 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)