Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Clearing port
#1
Hello—

I am defining a port in a procedure:

R=RotaryEncoderModule('/dev/cu.usbmodem2812891');

When I exit and restart the protocol I am met with:

Error using ArCOMObject_Bpod (line 129)

Error: Unable to connect to port /dev/cu.usbmodem2812891. The port may be in use by another application.

The command clear R does not remedy the situation and my only option appears to be to restart Matlab.

Any suggestions?

Thank you,

Randy
Reply


Messages In This Thread
Clearing port - by rchitwood - 01-25-2018, 05:00 PM
RE: Clearing port - by Josh - 01-25-2018, 07:43 PM
RE: Clearing port - by rchitwood - 02-05-2018, 04:07 PM

Forum Jump: