02-18-2020, 06:52 PM
Josh or other Bpoders
The drill holes in the PCB file for the DC barrel Jack on the Bpod v2.3 appear to be large circles rather than thin ovals. Any reason for the change? The digi-key barrel jack part number is the same as listed on the wiki so I'm assuming it'll still fit.
Thanks
Chuck
The drill holes in the PCB file for the DC barrel Jack on the Bpod v2.3 appear to be large circles rather than thin ovals. Any reason for the change? The digi-key barrel jack part number is the same as listed on the wiki so I'm assuming it'll still fit.
Thanks
Chuck