Forums
BNC input logic - Printable Version

+- Forums (https://sanworks.io/forum)
+-- Forum: Bpod (https://sanworks.io/forum/forumdisplay.php?fid=1)
+--- Forum: Software (https://sanworks.io/forum/forumdisplay.php?fid=6)
+--- Thread: BNC input logic (/showthread.php?tid=764)



BNC input logic - MarcoC - 03-10-2020

Hello everyone!
I was wondering if the State Machine accepts a 0-5V logic (I want to use an arduino's digital input to trigger a new state) with 0 being the LOW level and 5V being the HIGH.

Thanks in advance!
Have a great day


RE: BNC input logic - Josh - 03-11-2020

Hi Marco,

All of the state machine's digital input channels are 5V tolerant - so you can definitely use an Arduino board to trigger a state change! You'd configure the Arduino pin as an output (not an input). Just make sure the incoming pulse lasts for at least 200 microseconds.

-Josh