Forums
Test curve for water - Printable Version

+- Forums (https://sanworks.io/forum)
+-- Forum: Bpod (https://sanworks.io/forum/forumdisplay.php?fid=1)
+--- Forum: Software (https://sanworks.io/forum/forumdisplay.php?fid=6)
+--- Thread: Test curve for water (/showthread.php?tid=605)



Test curve for water - Sarah - 05-27-2019

Hi, I just installed a bpod (2.0), everything seems to work fine, except for the water valve (Bpod set up using only 1 water valve and no other modules). I am not sure it uses the calibration file...
Water valve is working and delivers water, I can calibrate new values in the calibration file but if I want to test it with the test curve, I have an error message and I cannot test the valve.
Any ideas? see below the error message


"Error using BpodLiquidCalibration>RunRewardCal (line 575)
Pulse durations should be specified in seconds.

Error in BpodLiquidCalibration>RunSpecificAmount (line 808)
    Completed = RunRewardCal(nPulses, TargetValves, PulseDurations, .2);
 
Error while evaluating UIControl Callback."


Thanks!
Sarah


RE: Test curve for water - Josh - 05-27-2019

Hi Sarah,


Please send your liquid calibration file to support@sanworks.io, and I'll have a look.
The file is in your /Bpod Local/ folder:

/Bpod Local/Calibration Files/LiquidCalibration.mat

Thanks,
Josh


RE: Test curve for water - Sarah - 05-27-2019

(05-27-2019, 09:25 PM)Josh Wrote: Hi Sarah,


Please send your liquid calibration file to support@sanworks.io, and I'll have a look.
The file is in your /Bpod Local/ folder:

/Bpod Local/Calibration Files/LiquidCalibration.mat

Thanks,
Josh

Thks!
I sent you the file from my gmail address.

Best,